Anvil Group Study Spaces

Description

A 60” LED Monitor is connected to all the display input cables located in the cable cubby. Bring your own laptop or other device. 

Step-by-step guide

Press the ON button on the Monitor Controller.
Your laptop connects to the Monitor through either the HDMI or VGA cable located in the Extron Cable Cubby on top of the table. Four cables are built-in: HDMI, VGA, Audio and Network. The system will auto-select and display your input. If audio is required for VGA, there is an audio cable in the Cable Cubby.
Adjust the volume knob on the Monitor Controller. To mute audio, select the MUTE button on the Monitor Controller. The Mute button turns red when muted.
If no audio, change the laptop Sound settings. Go to Start>Control Panel>Sound The Sound window appears with the Playback folder open. Set to HDMI, or, set the default device to whichever one is playing sound. Sound volume will be visible as green bars moving up and down as you play audio on the laptop
No laptop image on screen? a) Hold down the Fn key and press F5, or the F key with a picture of a computer and screen on it. b) Cycle through the settings and select one. Wait a few seconds between settings; the laptop needs time to switch between display modes.
Power Down to conserve energy by turning off all equipment. Turn off the display by selecting the OFF button on the Monitor Controller.

General Technical Support

Phone 604.527.5330
Email servicedesk@douglascollege.ca